CP Series
OptoTEC™ Series
PolarTEC™ (PT) Series
Center Hole (Annular) Series
Multistage (Cascade) Series
ThermaTEC™ (HT) Series
UltraTEC™ (UT) Series
 
 
 
 

 
   
  Center Hole (Annular) Series
 
 
  • Features center hole for transmission of light, wires, probes or other hardware through the TEC

  • Round or square configurations available
   
 
Mechanical Characteristics
 
OptoTEC F3 Series SH Series RH Series
Wire Standards
Module Type
Wire Gauge (AWG)
OT-ALL
30
SH0.8-ALL
26
SH1.0-ALL
24
SH1.4-ALL
18
RH1.4-ALL
18
For all OptoTEC Series modules, wire is solid, uninsulated and 50mm (2.0 in.) long.
For all SH and RH Series modules, wire is stranded, 114 mm (4.5 in.) long and PVC insulated.
 


Moisture Protection Options
(Click to view sealing methods for moisture protection.)

 
 
Center Hole (Annular) Series Specifications
Catalog Number1 Datasheet Qmax2
(Watts)		 TH = 25°C N Dimensions (mm)
Imax
(Amps)		 Vmax
(Volts)		 ΔTmax
(°C)		 A B C D3 E
RH 1.4-14-10 3.7 3.9 1.7 68 14 26 26 26 4.7 14.0
RH 1.4-14-06 5.7 6.0 1.7 67 14 26 26 26 3.8 14.0
RH 1.4-32-06 12.9 6.0 3.9 67 32 44 55 55 3.8 27.0
SH 1.0-23-06 4.7 3.0 2.8 67 23 15 15 15 3.6 7.2
SH 0.8-28-05 4.9 2.6 3.9 67 28 14.7 10.3 14.7 3.1 4.4
SH 1.0-125-05 32.9 3.9 15.2 67 125 30 30 30 3.2 3.6
SH14,125,10,L1   32.9 3.9 15.2 68 125 40 40 40 4.7 4.7
SH 1.4-125-06 50.7 6.0 15.2 67 125 40 40 40 3.8 4.7
SH 1.4-125-045 67.7 8.5 15.2 65 125 40 40 40 3.3 4.7
1Please specify the surface finish by adding one of the following codes to the end of the catalog number:
M/M Metallized Hot and/or Cold face
L/L Non-Metallized Hot and/or Cold face
T/T Pre-tinning Hot and/or Cold face with 118°C InSn Solder
T93/T93 Pre-tinning Hot and/or Cold face with 93°C InSnCd Solder
2 Conditions for Qmax: DT = 0°, I = Imax, V = Vmax, and TH = 25°C.
3 Thickness is for Type L only.

Note: Maximum Operating Temperature for Center Hole Series Module is 80° C